домой, отправка сообщений

 

отправить
сообщение

список
операторов

описания
пейджеров

барахолки
NEW!

технич.
документ.


Техническое руководство по пейджинговому передатчику MOTOROLA NUCLEUS

SECTION 6: MECHANICAL INSTALLATION
Mounting Procedures (continued)











Be sure to install the power supply assemblies in the same locations as when received.

Step 7. Route the supplied power supply cables through the right side (viewed from rear) wiring access hole. Connect the power cables to the power supply ac power connectors.

Step 8. Route the rf antenna cable from the rf output connector through the left side wiring access hole.

Step 9. If peripheral bracket was removed, reinstall bracket and reconnect any cables which were disconnected. Secure bracket with screws removed in Step 5 of Remove Fan Door / Fan Shroud.

Step 10. Reinstall fan door on hinge pins and reconnect fan cable. Check to be sure all internal connections are completed.

Step 11. Close fan door and secure by pushing inward on two quarter-turn fasteners while rotating clockwise.

Step 12. Reinstall power amplifier assembly in chassis. Push inward far enough to reconnect rf cable at lower right side. Reconnect cable, then carefully push inward until seated Secure to chassis and frame using four supplied black M6 screws.

Step 13. Reinstall two power supply assemblies in the original location and secure with original TORX screws.

Step 14. Remove two installation aid screws installed in Step 1.


 

Nucleus

Figure 6-10 Nucleus Advanced Control High Power Station with Fan Shroud Installed - Rear View

6_17
<< предыдущаясодержаниеследующая >>


    © pagers.ru 1998-2018         |       hosted by olven.su        |   designed by zotov n. & cats